通用熱壓鑲嵌機產品介紹
該款通用熱壓鑲嵌機適用于具有多種鑲嵌樣需求的實驗室用戶。采用預編程記錄各種鑲嵌方法，可對不同尺寸的鑲嵌樣進行重復制作。
產品優點：
可編程性降低復雜性
適用于有多種鑲嵌樣需求且鑲嵌尺寸不同的實驗室。
存儲和撤銷5種不同的程序，降低復雜性和消除錯誤，提供靈活性來滿足多變的實驗室要求
通過選擇不同尺寸的模具來優化各種各樣的試樣大小。節約鑲嵌介質并提升鑲嵌質量
Specifications | |
Operation | Automatic electro-hydraulic |
Power Source | 85-264VAC, 50/60Hz, 1 phase |
Molding Pressure | 1200 - 4400psi [80 - 300bar] in 100psi [5bar] increments |
Molding Temperature | 120 - 360°F [50 - 80°C] in 20°F [10°C] increments |
Heating Power | 1500Watt @ 115/230VAC |
Heating Time | 0 - 20 minutes in 10 second increments |
Cooling Time | 0 - 30 minutes in 10 second increments |
Mold Type | Cylindrical, including upper and lower rams and duplex mold spacer |
Closure Type | Insluated bayonet with piston indent |
Mold Diameters | 1in, 1.25in, 1.5in, 2in, 25mm, 30mm, 40mm, 50mm |
Touch-pad Controls | On/Off; Heat Time; Cool Time; Molding Temperature; Molding Pressure; Mold Size; Ram Up/Down; Maunal Cool; Cycle Start; Cylinder Open; Unit of Measure; Language and also including Thermoplastic; Load and Save Methods |
Units of Measure | Imperial or Metric |
Water Flow Rate | 0.5gal/min [2?/min] minimum |
Water Pressure | 45-75psi [3-5bar] |
Control Voltage | 24VDC |
Method Programmability | 4 Buehler, Preprogrammed Methods per mold size; 25 User Definable Methods |
Preload Pressure | 0 - 400psi [0 - 30bar] in 50psi [5bar] increments |
Thermoplastic Function | Automatically sets correct parameters for thermoplastic resins such as TransOptic? and cools the mount in a controlled, linear fashion |
Compliance | In accordance with EC Directives |
